Hogeschool van Amsterdam

Centre for Applied Research of the Faculty on Digital Media & Creative Industries

Sticker cutter

Make your own stickers!

The Roland GX-24 sticker cutter uses a rotating blade to cut shapes out of sticker foil / vinyl foil.

Cutting process with the sticker cutter

The cut lines of your design can be made using the Illustrator software program. Via a software plug-in your design is then opened in the CutStudio program that controls the cutting machine itself. The machine cuts down through the sticker sheet as far as the underlying paper layer. It is also possible to cut pre-printed sticker material if they are provided with "crop marks".

Would you like to cut stickers? Make an appointment. One of our staff members will give you instructions on how to use the 3D printer. This takes about 20 minutes.

  • Bring your own materials, or make use of any cut-offs in the Lab
  • For sticker sheet sales locations see this page
  • Transfer sheet is available in the Lab

  • Cutting area width: minimum 3 cm, maximum 58 cm
  • Cutting area length: maximum 500 cm
  • Material width: minimum 5 cm, maximum 65 cm

Published by  Centre for Applied Research FDMCI 22 March 2021